SCA_ISensor(SCA_ILogicBrick)
base class — SCA_ILogicBrick
- class bge.types.SCA_ISensor(SCA_ILogicBrick)
Base class for all sensor logic bricks.
- usePosPulseMode
Flag to turn positive pulse mode on and off.
- Type
boolean
- useNegPulseMode
Flag to turn negative pulse mode on and off.
- Type
boolean
- frequency
The frequency for pulse mode sensors.
- Type
integer
Deprecated since version 0.0.1: Use
skippedTicks
- skippedTicks
Number of logic ticks skipped between 2 active pulses
- Type
integer
- level
level Option whether to detect level or edge transition when entering a state. It makes a difference only in case of logic state transition (state actuator). A level detector will immediately generate a pulse, negative or positive depending on the sensor condition, as soon as the state is activated. A edge detector will wait for a state change before generating a pulse. note: mutually exclusive with
tap, enabling will disabletap.- Type
boolean
- tap
When enabled only sensors that are just activated will send a positive event, after this they will be detected as negative by the controllers. This will make a key thats held act as if its only tapped for an instant. note: mutually exclusive with
level, enabling will disablelevel.- Type
boolean
- invert
Flag to set if this sensor activates on positive or negative events.
- Type
boolean
- triggered
True if this sensor brick is in a positive state. (read-only).
- Type
boolean
- positive
True if this sensor brick is in a positive state. (read-only).
- Type
boolean
- pos_ticks
The number of ticks since the last positive pulse (read-only).
- Type
int
- neg_ticks
The number of ticks since the last negative pulse (read-only).
- Type
int
- status
The status of the sensor (read-only): can be one of these constants.
- Type
int
Note
This convenient attribute combines the values of triggered and positive attributes.
- reset()
Reset sensor internal state, effect depends on the type of sensor and settings.
The sensor is put in its initial state as if it was just activated.